Troubleshooting - Yamaha RX-V2500 Owner's Manual

TROUBLESHOOTING

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the power cable, and contact the
nearest authorized YAMAHA dealer or service center.
General
Problem
This unit fails to turn
on when STANDBY/
ON (or SYSTEM
POWER) is pressed,
or enters in the
standby mode soon
after the power has
been turned on.
No sound
No picture
92
TROUBLESHOOTING
Cause
The power cable is not connected or the
plug is not completely inserted.
The impedance setting is incorrect.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
Incorrect input or output cable
connections.
The optimizer microphone is connected.
The input mode is set to "DTS" or
"ANALOG".
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
The input mode is set to "ANALOG"
while playing a source encoded with a
DTS signal.
The signals this unit cannot reproduce are
being received from a source component
e.g.: a CD-ROM.
The output and input for the picture are
connected to different types of video
jacks.
Remedy
Connect the power cable firmly.
Set the impedance to match your speakers.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
Set this unit in the standby mode, disconnect the
power cable, plug it back in after 30 seconds, then use
it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Disconnect the optimizer microphone.
Set the input mode to "AUTO".
Select an appropriate input source with INPUT,
MULTI CH INPUT or the input selector buttons.
Secure the connections.
Select the front speakers with SPEAKERS A and/or
B.
Turn up the volume.
Press MUTE or any operation buttons of this unit to
cancel a mute and adjust the volume.
Set the input mode to "AUTO" or "DTS".
Play a source whose signals this unit can reproduce.
Turn on the video conversion function.
Refer to
page
—
25
13–16
—
17–22
—
39
32
13
32
—
34
39
—
62