Yamaha RX-V2500 Owner's Manual page 74

REMOTE CONTROL FEATURES
4
Press LEARN using a ballpoint pen or similar
object.
"LEARN" and the selected component name (ex.
"DVD") appear alternately in the display window.
LEARN
Notes
• Do not press and hold LEARN. If you hold it down for
more than 3 seconds, the remote enters the remote control
code setting mode.
• If you do not complete each of the following steps within
30 seconds, the learning mode will be automatically
canceled. In this case, press LEARN again.
5
Press the button for which you want to
program the new function.
"LEARN" appears in the display window.
6
Press and hold the button you want to
program on the other remote control until
"OK" appears in the display window.
"NG" appears in the display window if learning was
unsuccessful. In this case, start over from step 5.
y
• If you want to program another function, repeat steps 5
and 6.
• If you continuously want to program another function for
another component, press the input selector button or
SELECT k/n to select the component, then repeat steps 3
through 6.
70
7
Press LEARN again to exit the learning
mode.
LEARN
Notes
• "ERROR" appears in the display window if you press a button
not indicated in the respective step, or when you press more
than one button simultaneously.
• This remote control can learn approximately 200 functions.
However, depending on the signals learned, "FULL" may
appear in the display before you program 200 functions. In this
case, clear unnecessary programmed functions to make room
for further learning.
• Learning may not be possible in the following cases:
– When the batteries in the remote control for this unit or other
components are weak.
– When the distance between the two remote controls is too
great or too small.
– When the remote control infrared windows are not facing each
other at the appropriate angle.
– When the remote control is exposed to direct sunlight.
– When the function to be programmed is continuous or
uncommon.