Manual Setup: Sound - Yamaha RX-V2500 Owner's Manual

Manual setup: Sound

Use this menu to adjust the sound parameters.
1
Set AMP/SOURCE/TV to AMP.
AMP
SOURCE
TV
2
Press TOP on the remote control.
3
Select Manual Setup, then press h.
Sound
Basic
Option
4
Select Sound, then press h.
5
Select the desired parameters, then press h
to access and adjust.
LFE Level (Low-frequency effect level)
Use to adjust the output level of the LFE (low-frequency
effect) channel according to the capacity of your
subwoofer or headphones. The LFE channel carries low-
frequency special effects which are only added to certain
scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
To access these parameters, select:
Manual Setup > Sound > LFE Level >
Choices: –20 to 0 (dB)
Speaker
Headphone
Speaker (Speaker)
Select to adjust the speaker LFE level.
Headphone (Headphone)
Select to adjust the headphone LFE level.
y
This menu item is also available in the front panel display system
options menu (see page 82).
LFE Level
Dynamic Range
Parametric EQ
Tone Control
Audio Option
0.0dB
Note
Depending on the settings of LFE Level, some signals may not be
output from the SUBWOOFER jack.
Dynamic Range (Dynamic range)
Use to select the amount of dynamic range compression to
be applied to your speakers and headphones. This setting
is effective only when the unit is decoding Dolby Digital
and DTS signals.
To access these parameters, select:
Manual Setup > Sound > Dynamic Range >
Choices: MAX (maximum), STD (standard),
MIN (minimum)
Speaker
Headphone
Speaker (Speaker)
Select to adjust the speaker compression.
Headphone (Headphone)
Select to adjust the headphone compression.
• Select "MAX" to preserve the greatest amount of
dynamic range.
• Select "STD" for general use.
• Select "MIN" for listening to sources at low volume
levels.
y
This menu item is also available in the front panel display system
options menu (see page 82).
SYSTEM OPTIONS
MAX
STD
MIN
55