Manual Setup: Option - Yamaha RX-V2500 Owner's Manual

SYSTEM OPTIONS
[

Manual setup: Option

This menu adjusts the optional system settings.
1
Set AMP/SOURCE/TV to AMP.
SOURCE
2
Press TOP on the remote control.
3
Select Manual Setup, then press h.
4
Select Option then press h.
Sound
Basic
Option
5
Select the desired parameters, then press h
to access and adjust.
6
When finished adjusting parameters, press
ENTER.
Display (Display)
Use this feature to adjust the GUI and front panel displays.
Manual Setup > Option > Display >
Display
Multi Zone
Surr.Initialize
Dimmer (Dimmer)
Use to adjust the brightness of the front panel display.
Choices: –4 to 0
62
AMP
TV
Display
Multi Zone
Surr.Initialize
Input Mode
Memory Guard
Dimmer
Video Conv.
Short Message
Position
Wall Paper
Video Conv. (Video conversion)
Use this feature to turn on/off conversion of composite
(VIDEO) signals to both S-video and component signals.
This allows you to output converted video signals from the
S VIDEO or COMPONENT VIDEO jacks when no
S-video or component signals are input. This feature also
converts S-video signals to component signals when no
component signals are input.
Choices: Off, On
• Select "Off" not to convert any signals.
• Select "On" to convert composite signals to S-video
and component signals, and to convert S-video signals
to component signals.
y
When using the THX system, we recommend setting Video Conv.
to "Off".
Notes
• Converted video signals are only output to the MONITOR OUT
jacks. When recording you must make the same type of video
connections (composite or S-video) between each component.
• When converting composite video or S-video signals from a
VCR to component video signals, the picture quality may suffer
depending on your VCR.
Short Message (Short message)
Use this feature to turn on/off the short message display.
Choices: Off, On
• Select "Off" to turn off the short message display.
• Select "On" to turn on the short message display.
Notes
• The short message display may not display properly depending
on the type of input signal and video monitor used.
• If Video Conv. is set to "Off", the short message display is not
displayed even if "On" is selected.
Position (Position)
Use to adjust the vertical and horizontal position of the
GUI display.
Choices: –5 (downward/left) to +5 (upward/right)
• Press k to raise the position of the GUI display.
• Press n to lower the position of the GUI display.
• Press h to shift the position of the GUI display to the
right.
• Press l to shift the position of the GUI display to the left.
Wall Paper (Wallpaper)
Use this feature to select the background when no image is
input from an external source. If you do not want to
display the background, select None.
Choices: None, Yes, Gray Back
Note
If Video Conv. is set to "Off", no background is displayed even if
"Yes" is selected.
y
This menu item is also available in the front panel display system
options menu (see page 82).