SawStop REVOLUTION TSA-RMG Owner's Manual page 26

Adjustment steps:
1. Insert the included 3mm hex wrench into the silver
screw shown in the illustration below. Turn it
counter-clockwise to loosen it slightly. The
adjustment bushing is now free to rotate.
2. Rotate the adjustment bushing as needed. The gear
mesh is tightest when the bushing marking is
furthest from the handle (12 o'clock).
3. When you are satisfied with the adjustment, re-
tighten the silver screw you loosened in step 1
using the included 3mm hex wrench. It is important
that this screw is tight.
Small adjustments have a big impact, so make a small
change, then test for play before making additional
adjustments.
|
26 Revolution MIter Gauge Owner's Manual