If you change the miter angle, the clearance
between the fence and blade may also
change. To minimize risk of injury and
damage to your miter gauge, re-confirm that
a safe margin of clearance is present
(described above) after any miter angle
adjustment is made.
INSTALL THE FLIP STOP ASSEMBLY
Use the following steps for initial installation of the Flip
Stop Assembly .
1. Move the red flip stop release lever to the 10
o'clock position as shown to open the clamp on the
underside of the Flip Stop Assembly . Slide the
bottom of the Flip Stop Assembly over the end of
the top rail of the Fence Assembly extrusion.
2. Continue to slide the Flip Stop Assembly along the
top of the Fence Assembly extrusion to the desired
distance from the blade.
|
10
Revolution MIter Gauge Owner's Manual
3. Move the red flip stop release to the 2 o'clock
position (as shown) to secure the Flip Stop
Assembly in place.
4. The Flip Stop Assembly is now installed and
positioned for your first cut. Reposition the Flip
Stop Assembly as needed for future cuts by
releasing the red, flip stop clamp as described
above, then securing it again at the new location.
If the flip stop hinges are sticky or difficult to move, adjust
the small hex bolt in the hinge body using the provided 2mm
hex wrench.
Be sure to visit the section on CALIBRATION on page 21 of
this manual for instructions on setting up the built-in ruler
to read accurately.
Congratulations! The assembly of your Revolution Miter
Gauge is now complete.
BASIC USE
This portion of the manual discusses basic use of your
Revolution Miter Gauge such as setting the miter angle,
using the fence system, and how to use the adjustable flip-
stop system. The main controls on your Revolution Miter
Gauge are labeled in the next illustration. These controls
are referenced by name in the instructions that follow.
Need help?
Do you have a question about the REVOLUTION TSA-RMG and is the answer not in the manual?