Operation; Available Accessories - BorMann BCD2620 Instruction Manual

E N

OPERATION

Tips and notes on handling the cordless impact wrench
General information:
• Check the accessory in the tool holder for proper fit before every application.
• The centre position of the clockwise/counter-clockwise rotation switch (lock) is suited for work breaks or tool change.
Screwing:
• In case of soft wood, screws can be screwed in without pre-drilling.
• In case of hard wood or large screws, it is recommended to use a drill for pre-drilling.
• When using countersunk screws, the drill hole should be countersunk beforehand.
• Especially smaller screws and bits may be damaged when selecting an excessive torque and/or speed of the tool.
Selecting the rotational direction
Note: To avoid damaging the gear, only change the rotational direction when the device is at a standstill.
The motor's rotational direction can be changed by means of the switch for clockwise/counter-clockwise rotation (2).
1. Press the switch for clockwise/counter-clockwise rotation (2) in all the way on that side towards which the motor shall rotate.
2. Carry out a short test run to see whether the rotational direction may damage the tool and/or workpiece.
3. If required, set the switch for clockwise/counter-clockwise rotation (2) to centre position (lock) to block the on/off switch (3).
I. Screwing in
Switching the device on and off
The device has a variable speed control. The more firmly you push the on/off
switch (3), the higher the speed.
1. Check whether the fixed tool is suitable for the intended application.
2. Check whether the workpiece is secured and the working surface is
prepared appropriately.
3. Press and hold the on/off switch (3) during screwing.
• The device operates with the previously selected settings.
• The LED work lamp is illuminated.
4. Let go of the on/off switch (3) to stop the device.
• The LED work light (15) turns off.
Info
The motor has an integrated brake that quickly stops the motor once you let
go of the on/switch (3).
Shutdown
1. Set the switch for clockwise/counter-clockwise rotation (2) to centre position (lock).
2. If required, allow the device to cool down.
3. Remove the battery from the device (see Start-up chapter).
4. Remove the tool from the device (see Start-up chapter).
5. Clean the device according to the Maintenance chapter.
6. Store the device according to the Storage chapter.

AVAILABLE ACCESSORIES

Warning: Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause injury.
7
II. Unscrewing
WWW.NIKOLAOUTOOLS.GR