Information About The Device; Transport And Storage - BorMann BCD2620 Instruction Manual

Table of Contents

Available languages

E N

INFORMATION ABOUT THE DEVICE

With its rotary percussion pulses, the cordless impact wrench generates a very high torque, which is particularly well suited for loosening seized or rusted

screws and nuts.

The integrated LED work light illuminates the workpiece or working surface, which makes the operator's job easier and safer.

The battery comes with its own battery level indication. This allows the operator to easily check the current charging status without having to connect it to the

device.

TRANSPORT AND STORAGE

Note: If you store or transport the device improperly, the device may be damaged. Read the information regarding transport and storage of the device.

Transport

For transporting the device, use the included transport case in order to protect the device from external factors.

Before transporting the device, observe the following:

• Switch off the device by setting for clockwise/counter-clockwise rotation to centre position (lock).

• Hold onto the plug while pulling the power cable of the charger out of the socket.

• Allow the device to cool down.

• Remove the battery from the device.

• Remove the accessory from the tool holder.

Observe the following when transporting or shipping Li-ion batteries:

• The user may transport the batteries by road without any additional requirements.

• If transport is carried out by third parties (e.g. air transport or forwarding company), special requirements as to the packaging and labelling must be

observed. This includes consulting a dangerous goods specialist when preparing the package.

• Only ship batteries if their housing is undamaged.

• Mask open terminals with tape and pack the battery in such a way that it cannot move inside the packaging.

• Please also observe any other national regulations.

Storage

Before storing the device, observe the following:

• Switch off the device by setting the switch for clockwise/counter-clockwise rotation to centre position (lock).

• Hold onto the plug while pulling the power cable of the charger out of the socket.

• Allow the device to cool down.

• Remove the battery from the device.

• Remove the accessory from the tool holder.

• Clean the device as described in the maintenance chapter.

• For storing the device, use the included transport case in order to protect the device from external factors.

• Do not store Li-ion batteries which are completely discharged. Storing discharged batteries can lead to a deep discharge and thus damage the battery.

When the device is not being used, store it in a dry area that is protected from frost, heat and dust.

Start-up

Charging the battery

Note: The battery can be damaged in case of improper charging. Remove the charger's plug before inserting or removing the battery. Never charge the battery

at ambient temperatures below 10 °C or above 40 °C.

The battery is partially charged upon delivery to avoid damage to the battery caused by a deep discharge.

Prior to initial start-up and when the battery is low (only the red LED in the battery level indication (12) is illuminated), the battery should be charged. To do

so, please proceed as follows:

1. Slide the battery (6) onto the quick charger (7) upside down until it locks in

place.

2. Insert the plug of the quick charger (7) into a properly fused socket.

• The red battery LED (8) lights up.

• Charging requires approx. one hour.

3. Wait until the red battery LED (8) goes off and the green battery LED (11)

lights up.

• The battery (6) is fully charged.

4. Hold onto the plug while pulling the power cable of the quick charger (7)

out of the socket.

• The battery (6) and the quick charger (7) may have become warm during