BorMann BCD2620 Instruction Manual page 6

Inserting the battery
1. Set the switch for clockwise/counter-clockwise rotation (2) to centre position
(lock).
2. Slide the battery (6) onto the device until it locks in place.
Removing the battery
1. Set the switch for clockwise/counter-clockwise rotation (2) to centre position
(lock).
2. Detach the battery (6) from the device by pressing and holding the unlocking
button (13, I.) and pulling the battery off the device (II.).
3. If required, charge the battery (6) as described in the section Charging the
battery.
Checking the battery status
The battery status is displayed as follows by the three LEDs of the battery level
indication (12).
LED colour Meaning
Green - Orange - Red Maximum charge/power
Orange - Red Medium charge/power
Red Weak charge - Recharge the battery
1. Press on the battery icon (16) on the battery (6).
• You can read the battery status from the battery level indication (12).
Tool change
The device is equipped with a tool holder with a locking mechanism for hexagon
bits. Please proceed as follows to remove or insert tools.
1. Set the switch for clockwise/counter-clockwise rotation (2) to centre position
(lock).
2. Push the locking mechanism at the tool holder (1) to the front and hold it
in place.
3. Remove the tool from the tool holder (1), if there is any.
4. Insert the desired tool in the tool holder (1).
Info
Please note that when using short bits you first have to insert the supplied
bit extension (9) into the tool holder (1). The insert the short bit into the bit
extension (9).
5. Let go of the locking mechanism at the tool holder (1).
Info
When unscrewing screws or loosening nuts, note the setting of the rotational
direction. On the clockwise/counter-clockwise rotation direction indicator (2)
you can see in which direction the screws or nuts will be screwed.
Using sockets
If you want to screw 3/4 hexagon nuts, you can use the adapter (10) and a
socket. To do so, please proceed as follows:
1. Insert the adapter (10) into the tool holder (1) as described in the chapter
Tool change.
3. Check the socket for tight fit.
6
WWW.NIKOLAOUTOOLS.GR
E N