HIKVISION N4225IH-DE User Manual page 75

User Manual of Network PTZ Camera
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
The User Name and Password should be assigned by your ISP.

For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The
password should be something of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers and special characters) in order
to increase the security of your product.

Proper configuration of all passwords and other security settings is the responsibility of
the installer and/or end-user.
4. Click
Configuring Port Settings
Purpose:
If there is a router and you want to access the camera through Wide Area Network (WAN), you
need to forward the 3 ports for the camera.
Steps:
1. Enter
the Port settings interface:
Configuration > Network > Basic Settings > Port
Set the
2. HTTP port, RTSP port and port of the camera.
HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
Server Port: The default port number is 8000.
3. Click
Configuring NAT (Network Address Translation) Settings
Purpose:
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices
© Hikvision
to save and exit the interface.
Figure 6-5 Port Settings
to save the settings.
68