Table of Contents
Advertisement
User Manual of Network PTZ Camera
2. Configure the Baud Rate, Data Bit, Stop Bit, Parity, Flow Control, and Usage.
If you want to connect the camera through RS-232 port, the parameters of the RS-232 should
be exactly the same with the parameters you configured here.
3. Click
RS-485
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of the PTZ
parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS-485
2. Set the RS-485 parameters and click
The Baud rate, PTZ Protocol and PTZ Address parameters of the camera should be exactly the
same as those of the control device.
© Hikvision
Figure 6-48 RS-232 Settings
to save the settings.
Figure 6-49 RS-485 Settings
to save the settings.
96
Advertisement
Table of Contents
