Figure 15. Installing a drive into the drive carrier
Next steps
1.
Install a 3.5-drive carrier into the drive
2. Follow the procedure listed in
Removing a 2.5-inch drive from the 3.5-inch drive adapter
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove 3.5-inch drive adapter from the 3.5-inch drive
NOTE:
A 2.5-inch cabled drive is installed in a 3.5-inch drive adapter, which is then installed in the 3.5-inch cabled drive
carrier.
Steps
1. Using a Phillips 1 screwdriver, remove the screws from the side of the 3.5-inch drive adapter.
30
Installing and removing system components
bay.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
carrier.