HIKVISION DS-7600NI-I2 Series User Manual page 85

2) Click , and click on the image 4 times respectively to draw each point of a quadrilateral
area.
3) Set Sensitivity and Detection Target.
Sensitivity
The higher the value is, the more easily the detection alarm can be triggered.
Detection Target
Select Detection Target as Human or Vehicle to discard alarms which are not triggered by
human or vehicle. Detection Target is only available for certain models.
4) Optional: Repeat above steps to draw more rules. Up to 4 rules are supports.
7. Click Arming Schedule to select an arming schedule type.
Note
If you set Arming Schedule as Custom, you can drag the cursor on time bar to set customized
arming schedule, or move the cursor on time bar and click
schedule.
8. Click Linkage Method to set linkage methods.
Linkage Method
Notify Surveillance
Center
Alarm Pop-Up Window
Buzzer
Send Email
Alarm Output
Record
Network Video Recorder User Manual
Table 13-6 Linkage Method Description
The device can send an exception or alarm signal to the remote
alarm host when an event occurs. The alarm host refers to the PC
installed with client software (e.g., iVMS-4200, iVMS-5200).
When an alarm is triggered, the local monitor displays the alarm
pop-up window.
When an alarm is detected, the buzzer will make an audible beep.
The system can send an email with alarm information to a user or
users when an alarm is detected.
The alarm output can be triggered by the alarm input, motion
detection, video tampering detection, face detection, line crossing
detection, and any all other events.
When an alarm is detected, the selected channel would record
videos.
Note
Video recording schedule shall be enabled for the channel,
otherwise this linkage would be invalid. You can go to System →
Storage Management → Storage Schedule → Video Recording to
configure video recording schedule.
Description
59
to set specified time