Configuring the Switch Using the Console Port
Step 1: Use the console cable to directly connect the switch console port to your computer.
Step 2: Launch the terminal simulation software such as Hyper Terminal on the computer.
Step 3: Configure the parameters of the terminal emulation software as follows: 9600 bits per
second, 8 data bits, no parity, 1 stop bit, and no flow control.
Step 4: Enter the default username and password (admin/admin).
Troubleshooting
Hardware Fault Analysis
1. Power and cooling systems—power and fan
2.
Port, cable and connection—ports on the front panel of the switch and the cables connecting
these ports
Faults Relative to Power and Cooling System
Do the following checkups to help remove the fault:
www.qsfptek.com
V2.0
0
8 / 9