Configuration - Omega MDS-DTM-RTD Series User Manual

4.4 Configuration

Connecting your meter to your computer
A USB Programming cable was included with your unit. This cable is only used
during the setup and configuration of your meter.
This cable does not remain connected during normal use.
Connect the -type connector to your PC and then connect
the B-type connector to the USB port on your meter.
NOTE:
Figure 4-6. USB Programming Cable
NOTE:
www.DataSheet.net/
Figure 4-7. USB Connector Location
4
Setup & Configuration
USB
4-4
Datasheet pdf - http://www.DataSheet4U.co.kr/