Section 7 - Maintenance; Calibration; Cleaning; Fuse Replacement - Omega MDS-DTM-RTD Series User Manual

Section 7 – Maintenance

7.1 Calibration

Your MDS-DTM-RTD Series Benchtop Meter has been built, tested, and factory
calibrated to meet or exceed the specifications listed here in this manual.
Information is provided below on how to have your unit returned for service.
If your meter requires service or factory re-calibration, please call our Customer
Service Department at 1-800-622-2378 or 203-359-1660. They will assist you in
arranging the return of your meter. We can also be reached on the Internet at
www.omega.com, e-mail: cservice@omega.com

7.2 Cleaning

Lightly dampen a soft, clean cloth with a mild cleaning solution and gently clean
the Benchtop Meter.

7.3 Fuse Replacement

For all models –12-24 Vdc.
Main Power Fusing:
(Rear Panel)
Remove all electrical connections and power before
attempting any maintenance or cleaning.
www.DataSheet.net/
Disconnect all power from source before attempting fuse
replacement.
For continued protection against the risk of fire, replace fuse
with only the same size, type, rating, and safety approvals
indicated here and on the rear panel of your unit.
ll power line connections to your unit are fused. When
operating on single-phase power source such as 120 Vac in
the US , the neutral line is also fused.
1 ea., F1A
UL./CSA/VDE Approval (5mm dia x 20mm long).
Maintenance
C UTION:
W RNING:
C UTION:
NOTE:
7
7-1
Datasheet pdf - http://www.DataSheet4U.co.kr/