Technical Safety Notes For Assembly And Installation; Intended Use; Modifications And Alterations - Fasel Elektronik FNT2000 Series Installation Instructions Manual

Sauna control
Table of Contents

Advertisement

Safety
1.1

Technical safety notes for assembly and installation

1.2

Intended use

This control Unit is exclusively meant for operation and control of saunas, saunas with
moisture and infrared cabins. The control devices are permitted for operation in houses
and commercial facilities.
Intended use
Claims of any type due to damages caused by improper use will not be accepted. Only
the user is responsible for damages caused by improper use.
1.3

Modifications and alterations

Modifications and alterations of the sauna control or installation can lead to unforeseen
dangers.
All technical modifications and add-ons to the sauna control require the written permis-
sion of the manufacturer.
4
– DANGER!
– The control device can be installed directly on the outer side of the
cabin or at another location, however not within the cabin
– Use the sauna control device only with a cover guard for sauna heat-
ers if one of the following option is enabled:
timer option (lockable in service menu)
remote start via option input, WEB-Control, App or KNX-module.
– Appropriate VDE applies to public saunas, that a control lamp, show-
ing, that the heater is switched on, is to install in the room of the super-
visor.
– This lamp can be connected to the clamp
– For switching off the mains, the power supply cable must be
equipped with a fuse with a contact opening width corresponding to the
requirements of the excess voltage category III for total disconnection.
– The main switch of the control unit must be accessible.
– The sensor of the thermostat must be installed in such a way that it is
not affected by the incoming cool air.
WARNING!
Danger if not used correctly
Any improper use of the sauna control can lead to dangerous situations.
Therefore:
– Use the sauna control correctly.
– Operate the sauna control only within the permissible room tempera-
ture and moisture range. → See technical data
– All the specifications in the operating manual and the installation
manual must be strictly adhered to.
(FLE-STB).
Installation instructions

Advertisement

Table of Contents
loading

Table of Contents