iFIT NordicTrack T 7.5 S User Manual page 9

2. Make sure that the power cord is unplugged.
Locate the Upright Wire (81) on the right side of
the Base (94). Remove the wire tie (not shown)
securing the Upright Wire to the Base.
Next, identify the Right Upright (90), and have a
second person hold it near the Base (94).
See the inset drawing. Locate the wire tie (A)
in the lower end of the Right Upright (90). Tie the
wire tie through the wire pull (B) on the Upright
Wire (81). Next, feed the Upright Wire into the
Right Upright, and pull the upper end of the wire
tie until the Upright Wire is routed through the
Right Upright as shown. Do not remove the
wire tie yet.
3. Lay the Right Upright (90) near the Base (94).
Next, locate the Grommet (77) on the Upright
Wire (81), and identify the small ear (R) on the
Grommet (see the inset drawing). Insert the ear
into the square hole (B) in the Right Upright, and
then press the Grommet into the square hole.
Make sure not to pinch the ground wire (C).
If there is a screw (D) preattached to the Right
Upright (90), remove and discard the screw.
Then, attach the ground wire (C) to the Right
Upright (90) with a Ground Screw (38).
2
A
B
81
94
3
9
81
A
90
81
77
R
94 38
81
77
C
B D
90
90