iFIT NordicTrack T 7.5 S User Manual page 16

17. Note: If the treadmill is assembled on a
smooth surface, it may roll forward in this
step.
Remove the two 5/16" x 3/4" Screws (4) from the
Latch Crossbar (41). Note: The Latch Crossbar
is not preattached to the treadmill.
Raise the Frame (56) to the upright position.
Have a second person hold the Frame until
step 19 is completed.
Orient the Latch Crossbar (41) as shown. Make
sure that the "This side toward belt" sticker
(N) is facing the treadmill. Attach the Latch
Crossbar to the brackets (O) on the Frame (56)
with the two 5/16" x 3/4" Screws (4) that you just
removed and two 5/16" Star Washers (11).
18. Remove the 5/16" Nut (34), the two 3/8" Thrust
Washers (14), and the 5/16" x 1 3/4" Bolt (6) from
the bracket on the Upright Base (94). Note: If
one of the 5/16" Bushings (101) comes out,
reinsert it.
Next, orient the Storage Latch (53) as shown.
Attach the lower end of the Storage Latch (53)
to the bracket on the Upright Base (94) with
the 5/16" x 1 3/4" Bolt (6), the two 3/8" Thrust
Washers (14), and the 5/16" Nut (34).
Then, raise the Storage Latch (53) to a vertical
position, and remove the tie (P).
17
O
11
4
56
18
P
34
14
16
N
41
O
11
4
53
94
101
14
6