iFIT NordicTrack T 7.5 S User Manual page 14

12. See the inset drawing. Grip the connector on
the Upright Wire (81). Then, press the small
latch (T) on the wire pull (B), and remove and
discard the wire pull and the wire tie.
Next, have a second person hold the console
assembly (J) near the Handrails (86). Connect
the console ground wire (K) to the Ground Wire
(58) on the Crossbar (93).
Next, insert the Upright Wire (81) through the
two indicated looped ties (L) on the console
assembly (J), and connect the Upright Wire to
the console wire (M). IMPORTANT: The wire
connectors should slide together easily and
snap into place with an audible click. If they
do not, turn one connector and try again.
You must connect the wires properly for your
treadmill to function properly.
13. Set the console assembly (J) on the brackets on
the Handrails (86). Do not pinch any wires.
Attach the console assembly (J) with the four
5/16" x 3/4" Screws (4) that you removed in
step 9 and four 5/16" Star Washers (11); do not
fully tighten the Screws yet.
Insert the excess Upright Wire (81) into the con-
sole assembly (J). Then, pull the two ties (L) tight
and cut off the ends of the ties.
12
J
M
L
81
L
86
13
J
86
L
81
11
4
14
K
93
58
T
81
B
86
11
4