Royal Enfield SCRAM 411 Owner's Manual page 109

WASHING PROCEDURE
13. Once the motorcycle has been ridden in salty conditions
or near coastal areas it is recommended to wash your
motorcycle with cold water. Please do not use warm
water for washing as it will damage the motorcycle due
to chemical reaction with the salt. After washing process
once the motorcycle is completely dry it is recommended
to apply anti corrosion spray on all the metal and chrome
plated areas to protect the parts from corrosion.
14. It is recommended not to apply the anti corrosion spray on
the brake discs.
AFTER WASHING
1. Ensure, the motorcycle is thoroughly dry by wiping with a clean
soft lint free absorbent cloth or chamois leather.
2. Remove all adhesive tapes.
3. Lubricate control cables, pivots for footrest, side stand, center
stand, brake and gear shifter linkages, drive chain etc. with lube
oil.
4. Polish the painted (Except matt finish) and plated surfaces using
recommended automobile polishing wax.
5. Start the engine and allow to run at an idling speed for a few
minutes to warm up engine.
6. Drive the motorcycle slowly, apply both the brakes
intermittently to dry up the water in brake pads.
7. Please clean/wipe out water spils completely inside the RH side
panel before keeping tool kit, first aid kit and other relevant
documents inside the right side panel.
Royal Enfield Scram 411 107