Chapter 2 Installation; Installation Procedure; Preparation For Installation; Antenna Installation - HIKVISION DS-3WF Series Quick Start Manual

Installation Procedure

Preparation for Installation

To avoid device damage or personal injury caused by improper usage of the device, please follow
the preparations below.
 Use the applicable power supply accessory to power the device.
 The distance between the AP and the CPE should be less than the suggested distance to secure
transmission rate.
 Make sure the water-proof cover is installed.
 It is suggested to manage the gap between the cover and device with fluid dispensing.
 Install the device in the place where the maintenance personnel can operate easily.
 Disconnect the power supply when you have the device serviced.
 The temperature of the cover area will be high when the device is working. In the circumstances,
only personnel with relevant professional knowledge, such as installation and maintenance
personnel, are allowed to operate the device.
 Make a plan before installation to ensure there is enough room for the antenna and the wireless
bridge on the selected mounting pole.

Antenna Installation

By using the attached accessories, the antenna can be installed onto a mounting pole (user supplied)
with a diameter of 30 to 70 mm.

Chapter 2 Installation

Installation Procedure
5