Table of Contents
Advertisement
TBK-NVR2100 Network Video Recorder Quick Start Guide
Chapter 2 Installation and Connections
2.1 NVR Installation
During installation of the NVR:
⚫ Use brackets for rack mounting.
⚫ Ensure ample room for audio and video cables.
⚫ When routing cables, ensure that the bend radius of the cables are no less than five times than
its diameter.
⚫ Connect the alarm cable.
⚫ Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
⚫ Ensure the NVR is grounded.
⚫ Environmental temperature should be within the range of -10 to +55º C, +14 to +131º F.
⚫ Environmental humidity should be within the range of 10% to 90%.
2.2 Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
Step 1 Remove the cover from device by unfastening the screws on panels.
Step 2 Connect the data cable and power cable.
1) Connect one end of data cable to the device motherboard.
2) Connect the other end of data cable to HDD.
3) Connect one end of power cable to HDD.
4) Connect the other end of power cable to the device motherboard.
www.tbkvision.com
Figure 2-1 Remove Cover
8
Advertisement
Table of Contents
