Cleaning And Maintenance - Jimmy BX7 Pro User Manual

Use of the Product
Insert the power cord into the machine and plug into the socket. Press on/off
button,the machine is in vacuuming+UV+tapping mode and all indicators light up. Press the
mode button to switch the machine to tapping+vacuuming mode. Press the mode button
again to switch the machine to UV+vacuuming mode. Press the mode button again to
switch back to the UV+tapping+vacuuming mode. Press on/off button again, the machine
stop working(The LED display area has the dust sensor function. When in clean state, the
dust concentration light turns blue. When in dirty state, the dust concentration light turns red.
As the dust concentration decreases, the dust concentration light slowly changes from red to
blue.)
Note:
1.When the LED display shows brush trapped mode and the icon flash, please clean the filter and
brushroll in time.
2.For safety reasons, the UV light only works within 3cm above object as well as less than 30
inclination degrees. Otherwise, the UV light will automatically turn off.
3.Do not touch the air outlet on the bottom of the machine in case of hand scald.
LED Display
Vacuum Mode
Brush trapped Mode
(When the dust is full
or brush trapped,
the icon flashes.)

Cleaning and Maintenance

Note:
1.Filters are available at dealers.
2.It is recommended to clean the dust cup after
each use. When the filter is blocked due to
excessive dust accumulation, it needs to be
cleaned and replaced if necessary.
Dust Cup Cleaning
1.Turn off the machine and unplug the
power cord. Then press the release button
and lift upward. (Figure 1)
UV Mode
1
Tap Mode
Dust concentration
light (Indicate dust
concentration change)
Release button
18