JIMMY BX6 - Anti-Mite Vacuum Cleaner Manual

Product Installation

Parts Name

Packing List

Name x 1
Vacuum Cleaner x 1
MIF Filtre x 1
Mini-brush x 1
User Guide x 1

Use of the Product

Insert the plug into the socket, when turn on machine, the machine is in UV light+tap vacuum mode, all indicators light up. Press mode button once, the machine changes to tap vacuum mode and relevant indicators light up. Press mode button again, the machine changes to UV light mode. Press mode button once again, the machine changes back to UV light+tap vacuum mode. Press on/off button again, the machine stop working.

Dust Sensor Indicator

1. When turn on machine, the dust sensor indicator light stays green.
2. When the machine vacuums a lot of dust and the indicator light turns red, indicating that the user needs to focus on cleaning this area.
3. When the machine vacuums moderate concentration dust and the indicator light turns orange, indicating that the user needs to keep cleaning this area.
4. When the machine vacuums little or no dust and the indicator light turns green, indicating that this area does not need to be cleaned.

Note: For safety reasons, the UV light only works within 3cm above object as well as less than 30 inclination degrees. Otherwise, the UV light will automatically turn off.

Cleaning and Maintenance

Note:

1. MIF Filters are available at dealers.
2. It is recommended to clean the dust cup after each use. when the filter is blocked due to excessive dust accumulation, it needs to be cleaned and replaced if necessary.

Dust Cup Cleaning

1. Turn off the machine and unplug the power cord. Then press the release button and lift upward.
   (Figure 1)
   
2. Hold the dust cup and dust cup lid separately, twist dust cup clockwise (Figure 2),
   
   remove it from dust cup to clean. (Figure 3)
   

Filter and Cyclone Cleaning

Hold the cyclone in one hand, pinch the "UP" logo with the other hand, and take out filter (Figure 4).

Do Not tap the filter in reverse side in case of filter clog (Figure 5).

Clean the cyclone metal filter with the attached mini brush.(Figure 6)

After cleaning dust cup, filter and cyclone, put cyclone into the dust cup and rotate the dust cup lid into the dust cup until until a "click" sound is heard.
(Figure 7)

Note:

1. Do Not miss the filter!
2. Use water or neutral reagents to clean dust cup and wipe with dry cloths. Do not wash the filter until it is necessary. Make sure the filter and dust cup are completely dry before another use.

Brushroll Cleaning

Turn off the machine and unplug the power cord, rotate the right lock knob anticlockwise with hand from locked position to unlock position (Figure 8)

to remove the brushroll to clean up. (Figure 9)

After brushroll cleaning, install the brushroll and the brushroll cover into the machine in turn and lock the latch of the brushroll.

Note: For safety reasons, please turn off the machine and unplug power cord before cleaning brushroll.

Maintenance and Storage

Please clean dust cup and filter after each use for further use. It is recommended to replace a filter after 30-50 hours of working time(depending on specific situation) for better use.

Any paper, lead glass, plastic will greatly affect the effect of UV light. Please wipe and clean the UV tube regularly for better use.

Do Not touch the UV tube as dirt will affect UV light effect.

Put the machine in cool and dry place if the machine is to be idled. Do Not leave it in direct sunlight or humid environment.

Trouble shooting

Please check the following trouble points before go to the maintenance department.

Note:I f fault remains after adopting the following solutions, contact after sale service or local distributor immediately.

Product Specifications

Technical Parameter

Circuit diagram

Cautions

1. Please read this instruction manual carefully before use and keep it properly for future use.
2. Never leave the machine working without supervision.
3. Keep this product beyond the reach of special individual such as children without adult supervision.
4. Keep the power cord away from sharp objects and do not drag the cord to move the machine in case of cord damage.
5. Do not use this product to clean water or wet dust. Do Not operate it in humid places (such as bathroom, toilet, laundry room, etc.) to avoid malfunction.
6. This product can ONLY use for cleaning of textiles such as mattresses, blankets, pillows, sofas, etc.
7. Do Not place the machine near heating appliances or expose it to direct sunlight in case of fire hazard.
8. For safety reasons, please do not use the product to clean hot objects such as carbon, cigarette butts, sharp objects such as broken glass, corrosive liquids, flammable and explosive materials such as gasoline and alcohol. Otherwise it may cause product damage or fire.
9. Do Not operate this machine with suction port blocked in case of product damage.
10. Do Not remove the brushroll cover or force the cover outward when the machine is powered on for safety reasons.
11. The product has UV light, for safety reasons, Do Not look at the bottom of the machine when the power is on in case of ultraviolet rays harming.
12. Do Not apply this product to plants. Excessive use of UV may cause object damage.
13. Do NOT sit on this product in case of personal injury and product damage.
14. Cut the power source in maintenance or off-service.
15. If the power cord is damaged, please ask for professional help of the manufacturer and other professionals for safety reasons.
16. Please turn off the power switch and unplug the power cord if the machine is to be idled. Do Not unplug the power cord with humid hand in case of electric shock.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download JIMMY BX6 - Anti-Mite Vacuum Cleaner Manual