enphase IQ8 Installation And Operation Manual page 30

I. Use the Enphase Installer App to delete the old microinverter serial number from the Enphase
IQ Gateway database. In the Enphase Installer App, once connected to the IQ Gateway:
Tap Micros > Manage
a.
b. Tap the checkbox
replaced.
c. Tap to
J. Add the new microinverter serial number to the gateway database by initiating a device scan
using one of the following methods:
a. Method 1: Initiate a scan using the Enphase Installer App
• In the Enphase Installer App, once connected to the IQ Gateway, navigate to
• From the Overview screen, tap Detected > Start Device Scan to start a new
• If device scanning on the IQ Gateway is inhibited, the app displays Scan
b. Method 2: Use an IQ Gateway
•
K. Log in to Enphase Installer Platform to use Enphase Installer Platform's Array Builder to add
the newly detected microinverter to the virtual array.
L. Ship the old microinverter to Enphase using the supplied return shipping label.
30
Enphase IQ8, IQ8+, IQ8M, IQ8A, and IQ8H Microinverters
.
to the right of the microinverter serial number that you
delete the microinverter from the IQ Gateway database.
the Overview screen.
30-minute device scan.
Inhibited. If you need to add more microinverters to the system when device
scanning is inhibited on the IQ Gateway, you must use the Enphase Installer
App scanning tool to provision them on the IQ Gateway rather than using the
IQ Gateway's device scanning function to discover them. If this is not
possible and you need to enable device scanning on the IQ Gateway, contact
Enphase Support at enphase.com/en-us/support/contact.
Press the Device Scan button on the IQ Gateway. The IQ Gateway begins a
15-minute scan to identify all of the microinverters deployed at the site. The
Microinverter Communications LED
© 2024 Enphase Energy Inc. All rights reserved.
flashes green during the scan
Microinverter communications LED
Device scan button
.
January 2024
IOM-00068-1.0