Technical Data - Nakayama PRO GS8700 Manual

EN

TECHNICAL DATA

Model GS8700
Chipping diameter 60 mm
Cutting length 50 - 100 mm
Blade speed 400 rpm
Engine type OHV 4-stroke
Starting system Recoil starter
Displacement 212 cc
Maximum output 7 hp
Engine speed 3600 rpm
Blades 6 pcs
Fuel / Oil volume 3.6 lt / 0.6 lt
Fuel type Unleaded
Net weight 110 kg
ASSEMBLY INSTRUCTIONS
Step 1: Installing the handle
1. Position the handle (A) underneath the engine base.
2. Secure the handle on the mount (D) using the two M8x40
bolts (C) and two nuts.
Step 3: Installing the support
1. Align the support (B) with the screw holes in the mount.
2. Secure the support on the mount (C) using the bolts (A).
4
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated in
the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with
similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work,
including maintenance and special adjustments, must only be carried out by technicians of the authorized service department
of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause
malfunctions or even serious injury or death. The manufacturer and the importer shall not be liable for injuries and damages
resulting from the use of non-conforming equipment.
WWW.NIKOLAOUTOOLS.COM
Step 2: Installing the wheels
1. Put the wheel (A) onto the axle (B).
2. Slide the washer onto the axle against the wheel.
3. Fit the nuts (C) to secure the wheel on the axle.
Step 4: Installing the feed hopper
1. Install the feed hopper (B) by aligning the assembly holes
and secure it using the bolt (D).
2. Tighten the nut to secure the feed hopper on the box (A).