Table of Contents
Advertisement
Display back-cover and antenna assembly
Removing the display back-cover and antenna assembly
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base cover for computers shipped with a plastic
3. Remove the
M.2 2230 solid-state drive for computers shipped with a plastic
4. Remove the
wireless card for computers shipped with a plastic
5. Remove the
display assembly for computers shipped with a plastic
6. Remove the
display bezel for computers shipped with a plastic
7. Remove the
display panel for computers shipped with a plastic
8. Remove the
camera for computer shipped with a plastic
About this task
NOTE:
The display back-cover and antenna assembly cannot be further disassembled once all the Prerequisites
are completed. If the wireless antennas are malfunctioning and are required to be replaced, replace the entire display
back-cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the Prerequisites have been performed.
Figure 86. Display back-cover and antenna assembly
118
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
computer.
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
chassis.
Advertisement
Table of Contents
