Installing The Display Assembly For Computers Shipped With A Plastic Chassis - Dell Inspiron 14 5440 Owner's Manual

Figure 69. Removing the display assembly
Steps
1. Remove the two screws (M2.5x4) that secure the left display hinge to the palm-rest and keyboard assembly.
2. Remove the two screws (M2.5x4) that secure the right display hinge to the palm-rest and keyboard assembly.
3. Peel the tape that secures the display-cable connector latch to the system board.
4. Lift the latch and disconnect the display cable from the connector on the system board.
5. Peel the tape that secures the wireless antenna cables to the system board.
6. Unroute the wireless antenna cables from the routing guides of the palm-rest and keyboard assembly.
7. Gently lift the palm-rest and keyboard assembly off the display assembly.
Installing the display assembly for computers shipped with a
plastic chassis
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs) 99