Table of Contents
Advertisement
Figure 40. Removing the battery
Steps
1. Peel the tape that secures the battery cable to the system board and disconnect the battery cable from the connector on
the system board.
2. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
Installing the 54 W battery for computers shipped with an
aluminum chassis
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the location of the battery and provides a visual representation of the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
67
Advertisement
Table of Contents
