Installing The Label - TSC TDP-643 User Manual

3.2 Installing the Label (Refer to Figure 3-2)
Note: (1) In order to avoid jammed or stuck labels, remove any curled
or damaged labels from the label roll before installation.
(2) Open the paper guide to its maximum width before loading
the labels.
1. Insert the spindle (2) into the core of the label roll.
2. With the label printing area (1) facing up. Place the label spindle
onto the two slots (3) of external roll mount supports.
3. Insert and push the label into the label insert opening (9) until it
stops.
4. Press and hold the FEED button (4) until the front edge of the label
roll ejects approximately half an inch out of the printer's label
dispense opening (5).
5. If the label roll is not centered within the feeder slot, open the front
cover by pushing down the release button of front cover (7). Push
the paper release button (6) to the back and hold it to adjust the
label to its proper position, then release the paper release button
and close the front cover.
6. Rewind the label roll to remove any slack and adjust the paper
guides (8) until they are close to the edges of the label roll without
bending the edges.
7. Press the FEED button until the READY indicator is on, then the
label is properly installed.
21