Functions; General - E+E Elektronik EE741 User Manual

Pipe diameter label
Fig. 3 Pipe diameter on gauge mounting block
Fig. 4 Pipe diameter on gauge mounting block with flanges
The pipe diameter setting of the sensing unit can be viewed and changed using the EE-PCS Product Configurator
Software and via the IO-Link interface.
On the optional display, the pipe diameter setting of the sensing unit can be viewed on the status page and can
be changed using the "Pipe diameter" menu. For further information see chapter 7 Display.
3.2

Functions

3.2.1.

General

Maximum consumption value on the display
The consumption value on the display is limited at 999 999 999.0 m
"LCD maximum", while internally the consumption is metered normally up to the maximum value of 3.4 * 10
Values above 999 999 999.0 m
Setting the Standard Conditions
The standardized volume flow calculation is based on the standard conditions stored in the EE741 sensing unit.
The factory setting for the standard conditions complies with DIN 1343:
pn = 1013.25 mbar (14.7 psi); Tn = 0 °C (32 °F)
The standard conditions can be changed via display menu, via EE-PCS Product Configurator Software or via
IO-Link.
Pipe diameter label
3
can be read with the EE-PCS Product Configurator Software.
User Manual EE741
3
. For value above this, the display shows
Inline Flow Sensor for Compressed Air and Gases | 8
38 3
m .