Mounting, Start-Up And Operation; Environmental Aspects; Scope Of Supply - E+E Elektronik EE741 User Manual

1.2.3.

Mounting, Start-up and Operation

The EE741 has been produced under state of the art manufacturing conditions, has been thoroughly tested and
has left the factory after fulfilling all safety criteria. The manufacturer has taken all precautions to ensure safe
operation of the device. The user must ensure that the device is set up and installed in a way that does not impair
its safe use. The user is responsible for observing all applicable local and international safety guidelines for
safe installation and operation of the device. This user manual contains information and warnings that must be
observed by the user in order to ensure safe operation.
PLEASE NOTE
The manufacturer or his authorized agent can only be held liable in case of willful or gross negligence. In any
case, the scope of liability is limited to the corresponding amount of the order issued to the manufacturer.
The manufacturer assumes no liability for damages incurred due to failure to comply with the applicable
regulations, operating instructions or the specified operating conditions. Consequential damages are
excluded from the liability.
WARNING
Non-compliance with the product documentation may cause accidents, personal injury or property damage.
▪
Mounting, installation, commissioning, start-up, operation and maintenance of the device may be
performed by qualified staff only. Such staff must be authorized by the operator of the facility to carry out
the mentioned activities.
▪
The qualified staff must have read and understood this user manual and must follow the instructions
contained within.The manufacturer accepts no responsibility for non-compliance with instructions,
recommendations and warnings.
▪
All process and electrical connections shall be thoroughly checked by authorized staff before putting the
device into operation.
▪
Do not install or start-up a device supposed to be faulty. Make sure that such devices are not used
accidentally by marking them clearly as faulty.
▪
A faulty device shall be removed from the process.
▪
Service operations other than described in this user manual may only be performed by the manufacturer.
1.3

Environmental Aspects

PLEASE NOTE
Products from E+E Elektronik Ges.m.b.H. are developed and manufactured in compliance with all relevant
environmental protection requirements. Please observe local regulations for the disposal of the device.
For disposal, the individual components of the device must be separated according to local recycling
regulations. The electronics shall be disposed of correctly as electronics waste.

2 Scope of Supply

Item 1 - EE741
▪
Inline Flow Sensor for Compressed Air and Gases according to ordering guide
▪
1x Allen key
▪
1x USB cable
▪
User manual
▪
Inspection certificate according to DIN EN 10204-3.1
Item2 - Gauge mounting block
▪
Gauge mounting block incl. sealing plug
User Manual EE741
Inline Flow Sensor for Compressed Air and Gases | 5