Mitsubishi Electric AE-50A Instruction Book page 23

Item
Fan Speed *1
Fan Mode *1
Prohibit Remote Controller
Operation
Filter Sign Reset
Schedule
Hold
Interlocked LOSSNAY
ON/OFF
Fan speed of interlocked
LOSSNAY
*1 The item may not be displayed, depending on the unit model.
WT07139X02
Click or to adjust the fan speed.
(Low) (Mid 2)
Note: Available fan speeds depend on the unit model.
This item will appear only on the operation settings screen for HWHP (CAHV) unit groups.
The fan can be set to keep rotating even while the unit is stopped to avoid snow
accumulation on the fan guard during the winter.
Select [Normal] to stop the fan while the unit is stopped. Select [Snow] to operate the fan
even while the unit is stopped.
The following operations or setting change from the local remote controllers and the Web
Browser for User can be prohibited: ON/OFF, Operation mode, Set temperature, Filter sign
reset, Air Direction, Fan Speed, and Timer.
Click the operation item [ON/OFF], [Mode], [Set Temp.], [Filter Sign], [Air Direction], [Fan
Speed], or [Timer] to switch the setting between
Note: For LOSSNAY unit, PWFY unit, and HWHP unit groups, the item [Mode] or [Set
Temp.] will not appear.
Note: [Air Direction], [Fan Speed], and [Timer] may not be displayed, depending on the unit
model.
Note: When the [ON/OFF] operation is prohibited and the "Automatic recovery after power
failure" switch on the indoor unit is set to "Turn off the power, or restore operation
regardless of the operation status immediately before power failure," the operation of
the indoor unit will not be restored, even when turned on after power restoration.
When the switch is set to "Turn off the power, or restore operation if the unit was in
operation immediately before power failure," the operation of the indoor unit will be
restored regardless of whether the [ON/OFF] operation is prohibited or not.
Refer to the indoor unit Installation Manual for details about switch settings.
Click [Reset] to switch between resetting and not resetting the filter sign. The rectangular
icon next to Reset will appear in yellow-green when it is set to Reset ( ).
Note: If a filter sign in the group has not been triggered, then the item [Filter Sign Reset] will
not appear.
Note: Filter sign of LOSSNAY units will not be reset.
Note: After the filter sign is reset, it takes up to an hour to clear the filter sign display on the
local remote controllers.
Click [Available] or [Not Available] to enable/disable the scheduled operations. When the
Schedule is enabled, the scheduled operations are disabled.
Note: The operations that have been scheduled on the remote controller will not be
disabled.
Click [ON] or [OFF] to enable/disable the Hold function. When the Hold function is enabled,
the scheduled operations are disabled.
Note: The operations that have been scheduled on the remote controller will also be
disabled.
Note: [Hold type] can be specified on the Basic System settings screen, accessible via the
Web Browser for Initial Settings.
Note: The Hold function can be used on the AE-200A/AE-50A/EW-50A, but not on the
AE-200E/AE-50E/EW-50E.
Click [ON] or [OFF] to turn on or off the interlocked LOSSNAY unit.
Note: For a group that is not connected to an interlocked LOSSNAY unit (ventilator), the
item [Interlocked LOSSNAY ON/OFF] will not appear.
Click or to adjust the fan speed of the interlocked LOSSNAY unit (ventilator).
Note: For a group that is not connected to an interlocked LOSSNAY unit, the item [Fan
speed of interlocked LOSSNAY] will not appear.
Description
(Mid 1) (High)
23
(Auto)
(Prohibit) or (Permit).