Installing The Microphone And Front Panel - Yaesu FT-857D Operating Manual
Hf/vhf/uhf ultra compact transceiver
Hide thumbs
Also See for FT-857D:
- Brochure & specs (2 pages) ,
- Cheat sheet (2 pages) ,
- Programming manual (1 page)
Table of Contents
Advertisement
I
NSTALLING THE
1. Insert the microphone's plug into the recessed jack on the transceiver, as shown in the
illustration.
2. You may position the microphone cable so as to cause it to exit from the side or the
bottom of the transceiver. Just route the cable into the appropriate channel provided, as
shown in the illustration.
3. Connect the Control cable between the Front Panel and Transceiver Body.
4. Install the Front Panel by sliding it into the position shown; you will hear a "click" when
the panel locks into place.
5. To remove the Front Panel, use your left thumb to push rearward (slightly) the latch on
the left-hand of the panel, then slide the Front Panel to the right and away from the
transceiver.
FT-857 Operating Manual
M
ICROPHONE AND
MODE
I
NSTALLATION
F
P
RONT
ANEL
DSP
DWN
TX/BUSY
UP
BAND
7
Hide quick links:
Advertisement
Table of Contents
