Yaesu FT-857D Operating Manual page 107

MENU MODE No-048 [ DSP MIC EQ ]
Function: Sets the DSP microphone equalization pattern.
Available Values: OFF/LPF/HPF/BOTH
Default: OFF
OFF: This function is disabled.
LPF: Lower frequencies are emphasized.
HPF: Higher frequencies are emphasized.
BOTH: Mid-range frequencies are emphasized.
MENU MODE No-049 [ DSP NR LEVEL ]
Function: Setting of the degree of DSP Noise Reduction.
Available Values: 1 ~ 16
Default: 8
MENU MODE No•050 [ EMERGENCY ] : USA Version only
Function: Enables Tx/Rx operation on the Alaska Emergency Channel, 5167.5 kHz.
Available Values: ON/OFF
Default: OFF
When this Menu Item is set to "ON," the spot frequency of 5167.5 kHz will be enabled. To
get to this frequency, use the SELECT knob to navigate; the Alaska Emergency Channel
will be found between the Memory channel "M-P5U" and "M-001."
Use of this frequency is restricted to amateurs operating in, or within 50 nautical miles (92.6
km) of, the U.S. State of Alaska, and it is to be used for emergency communications only
(involving the immediate protection of life or property).
MENU MODE No•051 [ FM MIC GAIN ]
Function: Adjusts the microphone gain level for the FM mode.
Available Values: 0 ~ 100
Default: 50
MENU MODE No-052 [ FM STEP ]
Function: Selects the tuning steps for the SELECT knob in the FM mode.
Available Values: 5/6.25/10/12.5/15/20/25/50 kHz
Default: Depends on operating band and transceiver version.
MENU MODE No•053 [ HOME Ò VFO ]
Function: Enables/disables the moving of HOME channel data to the VFO.
Available Values: ON/OFF
Default: ON
Recall the HOME channel, then rotate the DIAL or SELECT knob. The data will now have
been copied to the current VFO, although the original HOME contents will remain intact on
the previously-stored HOME channel.
FT-857 Operating Manual
M O
ENU PERATION
105