Yaesu FT-857D Operating Manual page 109

MENU MODE No•057 [ MEM/VFO DIAL MODE ]
Function: Selects the function which is engaged when you press the SELECT knob thereby
activating its "secondary" function).
Available Values: CW SIDETONE, CW SPEED, MHz/MEM GRP, MIC GAIN, NB LEVEL,
RF POWER/STEP
Default: MHz/MEM GRP
MENU MODE No•058 [ MIC SCAN ]
Function: Enables/disables scanning access via the microphone's [ UP ] / [ DWN ] keys.
Available Values: OFF/ON
Default: ON
MENU MODE No•059 [ MIC SEL ]
Function: The choice of the equipment which connects to the MIC jack.
Available Values: NOR/RMT/CAT
Default: NOR
NOR: Normal Microphone.
RMT: Optional MH-59
CAT: CAT system: if you are using the optional FC-30 antenna tuner, you can still use the
CAT system by connecting the serial Data cable to the MIC jack.
MENU MODE No•060 [ MTR ARX SEL ]
Function: Selects the analog meter display configuration while the transceiver is receiving.
Available Values: SIG, CTR, VLT, N/A, FS, OFF
Default: SIG
SIG: Indicates the incoming signal strength.
CTR: Discriminator center meter.
VLT: Indicates the battery voltage.
N/A: Not available at this time.
Applies a calibration signal (1 mA for full scale) at the METER Jack on the trans-
FS:
ceiver bottom, for adjustment of an external meter's calibration. This lets you adjust
the external potentiometer in your metering system so that the external meter reading
is full scale.
OFF: Disables the meter.
FT-857 Operating Manual
Remote Microphone.
A8J
M O
ENU PERATION
107