Assembly 37; Dealer Set-Up Instructions - Woods BW10.52 Operator's Manual

DEALER SET-UP INSTRUCTIONS

Assembly of this cutter is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 76.
Select a suitable working area. A smooth hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
Complete the checklist on page 41 when assembly is
complete and cutter is delivered to the customer.
■ Before working underneath, carefully read
Operator's Manual instructions, disconnect
driveline, raise mower, securely block up all cor-
ners with jackstands, and check stability. Secure
blocking prevents equipment from dropping
due to hydraulic leak down, hydraulic system
failures, or mechanical component failures.
■ Do not disconnect hydraulic lines until engine is
stopped, power unit is properly secured, equip-
ment and all components are lowered to the
ground, and system pressure is released by op-
erating all valve control levers.
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
safety glasses or goggles, sturdy, rough-soled
work shoes, gloves, and hearing protection.
Respiratory protection may be required, de-
pending on the work.
MAN1352
( 01/18/2024 )
MAN1352_2024-01.indd 37 MAN1352_2024-01.indd 37
ASSEMBLY INSTRUCTIONS
WARNING
CAUTION
Install Wheel
HHCS 1/2 NC X 3-1/4
NUT, 1/2-20 UNF FLANGE
CD9356
Figure 23. Center Section Wheel and Hub Installation
Install Wing Wheel
(Figure 24)
WARNING
■ Wheel assemblies are heavy and can cause
muscle strain or back injury. Use lifting aids and
proper lifting techniques when handling.
1. Insert wheel hub into wing wheel yoke arms (5) and
align holes.
2. Secure into position using cap screw (83) and lock
nut (88).
3. Attach wheel to hub using five flanged nuts. Tighten
to 85 lbs-ft. Check that tire air pressure is a maxi-
mum of 40 psi.
4. Install optional dual wheel and hub to inside of
wheel yoke arm.
NOTE: Notat, (laminated), severe-duty ag, and
used aircraft tires are available. See page 64 for
parts list.

Assembly 37

NUT LOCK 1/2 NC ZP
HUB, 5 BOLT
1/19/24 1:05 PM 1/19/24 1:05 PM