Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 80.
Select a suitable working area. A smooth hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
Complete the checklist on page 39 when assembly is
complete and cutter is delivered to the customer.
WARNING
■ Before working underneath, carefully read
Operator's Manual instructions, disconnect
driveline, raise mower, securely block up all cor-
ners with jackstands, and check stability. Secure
blocking prevents equipment from dropping
due to hydraulic leak down, hydraulic system
failures, or mechanical component failures.
■ Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
CAUTION
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing,
and head; and respirator or filter mask where
appropriate.
36 Assembly
MAN1282_2023-04.indd 36
MAN1282_2023-04.indd 36
ASSEMBLY
Install Wheel
88
Chamfer
Figure 22. Center Section Wheel and Hub Installation
Winch Kit Installation
See Parts page 77 for parts list and diagram.
5
Center of
Cylinder Lug
Figure 23. Roller Assembly Installation
1. Locate and drill one 9/16" hole in each wing using
dimensions shown in Figure 23. Assemble items 1,
2, 3 and 4. Use assembly to locate and drill remain-
ing holes.
2. Secure idler brackets (1) and rollers (2) to deck with
bolts (5) and nuts (6).
3. Remove cylinder pin: Place channel (10) over cyl-
inder and cylinder lug. Place wing lock-up bracket
over channel and insert pin (8), washers (7), and
cotter pins (9). NOTE: Washers (7) are used as
spacers and are placed between lock-up bracket
and channel (10) as needed.
Install Optional
Wheel and Hub
83
5
CD7837-1
1. Center Wheel Yoke Arm
83. 1/2" NC x 3" HHCS GR5
88. 1/2" NC Flange Lock Nut
Flat
1
1.5"
1.5"
6
4
3
1
2
CD6947-1
MAN1282
( 04/18/23 )
4/18/23 2:54 PM
4/18/23 2:54 PM
Advertisement
Table of Contents
