Storage - Woods BW10.52 Operator's Manual

NARROW
Figure 3. Transport Lock Pin in Standard & Narrow
3. Place lock pin and klik pin in lock position and lower
cutter against lock pin.
■ For road transport less than 10 feet wide, place
lock pin in narrow transport position. See Figure
3.
4. To lower cutter for operation, extend hydraulic cylin-
der to raise cutter. Move lock pin from lock position
to storage position (Figure 4).
5. Lower cutter to desired cutting height
6. Clip stroke control bushings on the lift cylinder rod to
maintain cutting height during use.
NOTE: Use the various sizes of bushings to
achieve the desired stack height. Extra bushings
can be clipped on the attitude rods for storage..
PIN STORED FOR OPERATION
Figure 4. Transport Lock Pin In Operation Position
MAN1352
( 01/18/2024 )
MAN1352_2024-01.indd 19 MAN1352_2024-01.indd 19
STANDARD
Width Positions
NOTICE

STORAGE

Follow these steps when storing your cutter:
1. Clean cutter before storing. See page 27 for clean-
ing instructions. Store on level, solid ground.
2. Disconnect input driveline from tractor and use the
SmartLift CV lift assist to store off the ground.
™
3. Lower wings to ground.
4. Raise cutter center section and pin transport bar in
raised position.
5. Attach parking jack and raise tongue weight off trac-
tor drawbar.
6. Place wedge blocks at front and rear of wheels
on center section and each wing to prevent wheel
rotation.
7. Securely block all four corners of center section and
each wing with jack stands.
8. Remove hydraulic hoses after tractor is turned off
and all system pressure is released by operating
valve levers several times.
9. Remove safety tow chain.
10. Remove retainer pin and high strength drawbar pin.
11. Keep children, bystanders, and animals away from
the equipment and the storage area.
Operation 19
1/19/24 1:05 PM 1/19/24 1:05 PM