Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 60.
Select a suitable working area. A smooth hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
Complete the checklist on page 35 when assembly is
complete and cutter is delivered to the customer.
WARNING
■ Before working underneath, carefully read
Operator's Manual instructions, disconnect
driveline, raise mower, securely block up all cor-
ners with jackstands, and check stability. Secure
blocking prevents equipment from dropping
due to hydraulic leak down, hydraulic system
failures, or mechanical component failures.
■ Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
CAUTION
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing,
and head; and respirator or filter mask where
appropriate.
Small Aircraft Tires
Tongue at 11"
Tongue at 18"
Large Aircraft Tires
Tongue at 11"
Tongue at 18"
MAN1339
( 05/17/22 )
ASSEMBLY INSTRUCTIONS
Attitude Rod Length
Beyond Nuts (34)
3.5
1.75
4.5
2.5
Install Wheel
Install Optional
Wheel and Hub
83
5
88
1. Center Wheel Yoke Arm
83. 1/2" NC x 3" HHCS GR5
88. 1/2" NC Flange Lock Nut
Flat
Chamfer
Figure 22. Center Section Wheel and Hub Installation
Install Wing Wheel
(Figure 23)
1. Insert wheel hub into wing wheel yoke arms (5) and
align holes.
2. Secure into position using cap screw (83) and
flanged lock nut (88).
3. Attach wheel to hub using five lug nuts. Install the
chamfered side of the lug nut toward the inside for
steel rim for pneumatic tires and rims. Tighten to 85
lbs-ft. Check that tire air pressure is a maximum of
40 psi.
NOTE: Install the flat side of the nut toward the in-
side for solid tires and aircraft tires (shown).
4. Install optional dual wheel and hub to inside of
wheel yoke arm.
NOTE: Pneumatic (BW15.71 and BW15.71Q only),
notat, and airplane tires are available for this cutter.
See page 49 for parts list.
Assembly 33
CD7837-1
Advertisement
Table of Contents
