Storage - Woods BW10.52 Operator's Manual

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
(Safety Rules continued from previous page)
■ Your dealer can supply genuine replacement
blades. Substitute blades may not meet orig-
inal equipment specifications and may be
dangerous.
■ Tighten all bolts, nuts, and screws to torque
chart specifications. Check that all cotter pins
are installed securely to ensure equipment is in
a safe condition before putting unit into service.
■ Make sure all safety decals are installed.
Replace if damaged. (See Safety Decals section
for location.)
■ Make sure shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
■ Never perform cleaning, service or maintenance
with engine running.
■ Do not disconnect hydraulic lines until engine
is stopped, power unit is properly secured,
equipment and all components are lowered to
the ground, and system pressure is released by
operating all valve control levers.
■ When lubricating telescoping PTO drives, keep
fingers out of shield access slots to prevent
injury.
■ Service and maintenance work not covered in
OWNER SERVICE must be done by a qualified
dealership. Special skills, tools, and safety pro-
cedures may be required. Failure to follow these
instructions can result in serious injury or death.
■ Explosive separation of tire and rim parts can
cause serious injury or death. Release all air
pressure before loosening bolts on wheel.
MAN1352
( 01/18/2024 )
MAN1352_2024-01.indd 11 MAN1352_2024-01.indd 11
SAFETY RULES

STORAGE

■ Before disconnecting and storing, follow these
instructions:
• Store on level, solid ground.
• Disengage power to equipment and wait for
all moving parts to stop.
• Disconnect input driveline from tractor and
use the SmartLift
the ground.
• Lower wings to ground.
• Raise cutter center section and pin transport
bar in raised position.
• Attach parking jack and raise tongue weight
off tractor drawbar.
• Place wedge blocks at front and rear of
wheels on center section and each wing to
prevent wheel rotation.
• Securely block all four corners of center sec-
tion and each wing with jackstands.
• Remove hydraulic hoses after tractor is
turned off and all system pressure is re-
leased by operating valve levers several
times.
• Remove safety tow chain.
• Remove retainer pin and high strength draw-
bar pin.
■ Keep children, bystanders, and animals away
from the equipment and the storage area.
CV lift assist to store off
™
Safety 11
1/19/24 1:05 PM 1/19/24 1:05 PM