Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 78.
Select a suitable working area. A smooth hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
Complete the check list on page 39 when assembly is
complete and cutter is delivered to the customer.
WARNING
WARNING
Before working underneath, carefully read Oper-
ator's Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
lic leak down, hydraulic system failures, or
mechanical component failures.
Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
CAUTION
CAUTION
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
36 Assembly
ASSEMBLY INSTRUCTIONS
Install Wheel
83. 1/2" NC x 3" HHCS GR5
88. 1/2" NC Flange Lock Nut
Figure 24. Center Section Wheel and
Hub Installation
Winch Kit Installation
See Parts page 77 for parts list and diagram.
Figure 25. Roller Assembly Installation
1. Locate and drill one 9/16" hole in each wing using
dimensions shown in Figure 25. Assemble items 1,
2, 3 and 4. Use assembly to locate and drill
remaining holes.
2. Secure idler brackets (1) and rollers (2) to deck
with bolts (5) and nuts (6).
3. Remove cylinder pin: Place channel (10) over
cylinder and cylinder lug. Place wing lock-up
bracket over channel and insert pin (8), washers
(7), and cotter pins (9). NOTE: Washers (7) are
used as spacers and are placed between lock-up
bracket and channel (10) as needed.
1. Center Wheel Yoke Arm
MAN1282 (3/09/2020)
Advertisement
Table of Contents
