Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Set-up of this cutter is the responsibility of the WOODS
dealer. It should be delivered to the owner completely
assembled, lubricated and adjusted for normal cutting
conditions.
The cutter is shipped fully assembled. Recommended
torque values for hardware are located on page 51.
Complete the check list on page 33 when assembly is
complete and cutter is delivered to the customer.
Before working underneath, carefully read Oper-
ator's Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
lic leak down , hydraulic system failu res, or
mechanical component failures.
Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
1. Vent plug
2. Swivel tee
3. Adapter
4. Adapter
5. Adapter
6. Hose
7. Coupler
8. Adapter
9. Hose
32 Assembly
ASSEMBLY INSTRUCTIONS
ARNING
Figure 22. Hose Set-Up
CAUTION
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
This cutter is fully assembled and adjusted at the fac-
tory with a two hose hydraulic set-up. One hose oper-
ates cut height adjustment. One hose operates wing
angle. For tractors with only one available hydraulic
outlet, follow the instructions below to change unit over.
1. Remove hose (6) attached to bulkhead fitting (5)
under height cylinder.
2. Remove the plug from side of cylinder.
3. Install adapter (3) found in manual tube into
cylinder.
4. Remove tee (2) from bulkhead fitting (5).
5. Install tee (2) onto cylinder adapter (3) just
installed.
Unit will now operate both height cylinders and wing
cylinders off of one hose.
MAN1126 (1/9/2015)
Advertisement
Table of Contents
