Table of Contents
Advertisement
10 Clean the fan with a soft brush. The
balancing weights may not be moved out
of place.
30
11 Reinsert the spiral housing in the
ventilation unit.
12 Reinsert the fan in the ventilation unit.
13 Refit the earthing wire and plug the
connectors removed earlier back into
their correct positions.
14 Mount the operating panel.
15 Reinsert the heat exchanger in the unit.
16 Screw the front cover back on.
17 Reinsert the filter in the unit with the clean
side towards the heat exchanger.
18 Close the filter shutter.
19 Switch the mains supply back on.
20 Switch the unit on at the operating panel
by pressing and holding the "OK" and "+"
buttons down at the same time for 3
seconds.
21 The filter status display has to be reset
after exchanging the filter by pressing the
"OK" button for 1 second.
Advertisement
Table of Contents
