Table of Contents
Advertisement
6.6.2 Changing settings by the installer
The installer can change more set values
than the user. If parameters are incorrectly
set, the performance of the unit is affected.
For this reason, make sure the parameters
are correctly set.
Please refer also to the menu structure
diagram in section 6.4.1 and the table in
section 6.6.3. Starting from operational mode,
the following steps are required for changing
settings. The example of changing parameter
I7 from 1 to 0 is used here.
1. Press button "F" for approx. 3 seconds to
activate the settings menu.
>3s
2. Press button "F" and "OK" for approx. 3
seconds to activate the parameter set for
the installer.
22
>3s
3. The required parameters can be called by
pressing and holding the "+" and "-"
buttons down together for 3 seconds.
4. Pressing the "OK" button calls this
setting.
5. Press and hold the "+" and "-" buttons
down together for 3 seconds to modify
the value.
Advertisement
Table of Contents
