Adjusting Input Size - Xerox DocuMate 3640 User Manual

Scanning from TWAIN

Adjusting Input Size

You can select one of the pre-defined input page size options in the list, or manually set the page size
by clicking and dragging a scan area in the preview window.
The following figure shows the input size options.
Paper Handling Options in the Advanced Interface:
• AutoCrop—Select this option to let the scanner automatically determine the size of the item being
scanned. For example, if you scan a 5"x 7" photo, the scanner will determine the size of the photo.
For single-sided scans, the scan area is the size of the image. For double-sided scans, the scan area
is the size of the larger of the two areas on the front and back of the page.
Straighten—Select this option to let the scanner automatically determine if a page is skewed,
•
then straighten its image. The scanner detects page edges and can sense when the page is fed
through at an angle. However, if the page is fed through at too great of an angle, the image may
not straighten correctly. In that case, re-scan the page using the paper guides to feed the paper in
straight.
• Double-Feed Detection—Selecting this option turns on the scanner hardware feature that detects
when multiple pages feed through the scanner at one time.
Abort—scanning stops and all pages scanned in this batch, up to this point, will be deleted.
Prompt—you will be prompted to remove the pages in the ADF, restack the remaining pages and
continue scanning. All pages scanned before and after the double page feed are saved.
74 DocuMate 3640
User's Guide