Making Copies On The Automatic Document Feeder (Xl2130F) - Xerox WorkCentre XL2120 User Manual

16
Making Copies on the Automatic
Document Feeder
The XL2130f ADF, with one scan, allows you to make one,
single sided, collated copy (1, 2, 3,...). You can also make
multiple single sided copies of each original (111..., 222...,
333...). The ADF holds up to 30 originals (20 lb/80 gsm) in one
job. Ensure originals are in good condition, and that all staples
and paper clips have been removed. Use the Document Glass
to make copies from transparencies, facsimile paper, or originals
having other unusual characteristics. For reliable copying
operation, use originals within the following ranges:
Paper weight range: 16 to 24 lb/60 to 90 gsm
Paper size range: 5.5 8.5"/A5, 8.5 11"/A4 and
8.5 14"/216 353 mm
The ADF comes from the factory with the Auto Start feature
enabled. Refer to Customizing Your Copier
User Guide for information about changing this setting.
1. Select the required Paper Tray.
2. Select the desired copy features from the Control Panel.
The maximum copy quantity is 1. Reinsert the originals
into the ADF for each set required.
3. Adjust the Original Guide to the original size.
Note: Writing that is very close to the leading or trailing edge of
the original may not copy. Turning the original around in the
ADF may help.
4. Insert up to 30 originals face up into the ADF until the green
SPF light on the WorkCentre diagram comes on.
(XL2130f)
section of this