Installation; Create The Fluidic Connections To The Device; Install Devices With Push-In Connection - Burkert 7015 Operating Instructions Manual

Type 7015, 7016

Installation

7 INSTALLATION
DANGER
Risk of injury due to high pressure and escaping medium.
▶ Switch off the pressure before working on the device or system. Vent or drain the pipes.
Risk of injury due to electric shock.
▶ Switch off voltage before working on the device or system. Secure against reactivation.
▶ Observe the applicable accident prevention and safety regulations for electrical devices.
WARNING
Risk of injury due to improper installation.
▶ Only trained technicians may perform installation work.
Risk of injury due to unintentional activation of the system and uncontrolled restart.
▶ Secure the system against unintentional activation.
▶ Following installation, ensure a controlled restart.
Prior to installation:
→ Clean pipes and flange connections.
→ Install dirt trap with a machine width of 5 μm in front of the valve.
7.1

Create the fluidic connections to the device

Installation position: any, preferably solenoid facing upward.
Note the flow direction. Letters X and Y label the flow direction. Ports X and Y are the inlet and outlet
in accordance with the device type label.
7.1.1

Install devices with push-in connection

Solenoid valve
Self tapping screws
Fig. 5: Installation of devices with push-in connection
english
13