Advertisement
INTEGRA/-S/-G/-GS User Manual
Modify mode
1) Indicates low, high, and delta values of the parameters (status mode); "Low value",
"High value" and "Delta value" fields for all parameters become editable when
"Default value" is deselected (modify mode);
2) Set all to default – resets "Low value", "High value" and "Delta value" for all
parameters to factory defaults;
3) Default value – deselect to activate manual threshold modification;
4) By pressing „Execute configuration", changes made to the corresponding section
apply only to the local side Integra/Integra-S/Integra-G/Integra-GS.
CLI commands
(Chapter 4: COMMAND LINE
log sensor info
log sensor mgmt <sensor>
control {enable|disable}
log sensor mgmt <sensor>
thold <min> <max> <delta>
log sensor mgmt <sensor>
time <0...30>
log default {all| group|
sensors [sensor]}
log sensor list
SAF Tehnika JSC
INTERFACE)
Use to show the configuration of sensor thresholds.
Use to enable or disable a sensor.
Use to set sensor's min, max thresholds, and delta values
manually.
Use to set sensor hysteresis time in seconds. Will be used to
show a value in orange color indicating that the sensor value
recently exceeded its thresholds.
Use to set group, individual sensor, or all sensor configuration
to default.
Use to list all available sensors.
WEB GUI
89
Advertisement
